MTB Coil Mounting Kit

Mounting a MIPS sensor to a coil shock can be a trial and error nightmare. You could spend a while mounting a sensor only to realize it was mounted short and MotionIQ is giving you a calibration error. This kit eliminates all of those headaches. Take off your shock, pull off the coil, insert the mounting plates and M4 snap joint posts, and you are up and running. Put the shock back on your bike, snap on the sensor, line it up, and calibrate. If you get an error, just loosen up the body clamp, open up the sensor a bit more, and calibrate. Best of all, when you are done testing, just remove the sensor by opening up the snap joint. Leave the plates on when you want to test again. This is a great solution if you have multiple bikes and are going to be swapping your sensors between bikes. 

If you want to check out how easy it is to mount, look at our install video.